| Better
representation of Flanges for sloped pipeline
|
Flanges were not always
aligned properly in flattened sloped pipelines.
OpenPlant Isometrics Manager
now properly represents Flanges for sloped pipeline.
|
| Improvement in
presentation of dummy leg support data
|
- Dummy leg
dimension value (length) is now displayed correctly for
OpenPlant Modeler
- Dummy leg
nominal diameter is now displayed correctly for
OpenPlant Modeler and AutoPLANT
Modeler.
|
| Slope depiction
|
OpenPlant Isometrics Manager has now ability to
show Slope depiction as Ratio.
|
| Visualization of
Eccentricity
|
Improved functionality for
displaying eccentricity for eccentrically tapped blind flange. Presentation of
pipeline in generated iso is now according to the UP/DOWN offset value of
tapped connection.
|
| Option to set the
coordinates precision in the PCF file.
|
|
| More control on
slope output
|
The slope output can be
presented as say 0.02 instead of 2%. A format specifier can now be inserted in
the "Text" portion of the slope dialog.
The above example uses the % value as input,
divides it by 100 and displays the value with exact 3 digits accuracy.
|
| Improved speed of
DWG/DXF format isometrics
|
Non-essential data now gets
removed before the DGN is converted to DWG which results in improved speed of
DWG/DXF format isometrics.
|
| Gasket
dimension
|
A config variable is added
which defines option to include a Gasket dimension at pipeline of nozzle
connection.
IE_UTH_DimensionUpToContinuation = true
With this variable defined in style.cfg, the
dimension includes the Gasket as well when there is connection of flange with
pipe or Equipment nozzle or loose gaskets on end of assembly.
|
| Better tracability
and better logging for solving problems with schema loading
|
A module is added which
verifies the availability and correct versions of primary schema along with all
referenced schemas. Detailed log is generated at temp location which identifies
the problem.
|
| Better
representation of detail sketches in output isometrics
|
When a detail sketch cell
contains non-horizontal text, it may be placed incorrectly in generated iso
sheet. That is repaired now.
|
| Better
representation of Text in DWG output
|
Dimension text in the
isometric DGN is by default in an isometric plane, in ACAD the dimension text
is flat in the isometric view. The standard 2D convertor does not necessarily
convert all dimension texts to text with the same height and width. An option
has been added to force a common height and width for the dimension texts.
|
| Additional
postprocessing for DWG/DXF output.
|
An extra section [0400] has
been added to hook.ini. This hook is only run in the 2D (DWG/DXF) environment.
This allows the DWG/DXF to use the by layer settings or make the isometric
appear as an imperial drawing.
|
